The Goodwe inverters are fully compatible with the Hubble range of batteries.
The following field guide will assist with the correct battery settings you should use.
​
For further detailed information ensure you read the manual of the supplied battery regarding the setup and installation instructions.
GOODWE INVERTER SET UP
INVERTER example
Model | Voltage | Bulk/Equalised (Vdc) | Float Voltage (Vdc) | Cutoff Voltage (Vdc) | Recommended Charge Amps | Max Discharge Current (A) |
|---|---|---|---|---|---|---|
S Series | 12V
| 14
| 14 | 12 | 30A | 100A |
X-100 | 48V | 52.8 | 52.8 | 44 | 30A | 100A |
X-101 | 48V | 53.8 | 53.8 | 44 | 30A | 100A |
X-200 | 36V | 41.5 | 41.5 | 34 | 30A | 100A |
AM-2 | 48V | 53.8 | 53.8 | 44 | 30A | 100A |
AM-3 | 48V | 53.8 | 53.8 | 44 | 20A | 50A |
AM-4 | 24V | 29 | 29 | 23.8 | 30A | 100A |
AM-5 | 48V | 55.2 | 55.2 | 47 | 30A | 100A |
AM-10 | 48V | 55.2 | 55.2 | 47 | 60A | 150A |
BLADE | 48V | 55.2 | 55.2 | 47 | 50A | 200A |
You can monitor your Goodwe inverter using the PV Master app. The below settings are the recommended settings to use for the corresponding Hubble Lithium battery, as seen on the PV Master App.
OPERATION MODE
SYSTEM DATA
WORK STATUS
INVERTER SETTINGS
pin layout
Below are the Hubble BMS, Cloudlink, and Goodwe side pinouts.
Note that the Hubble Lithium BMS pinouts are the same as the Cloudlink CAN pinouts
HUBBLE DIP SWITCH SETTINGS FOR MULTIPLE BATTERY INSTALLATION
​
​For correct setup and communication each battery needs a unique serial address in order to communicate. If you are only using one battery in your setup, consider this the master battery and ensure you set it to address 1.
am-2
am-5 & AM-10
How do you setup multiple batteries?
See table above and check your product manual for a more detailed explanation. You will have to set dip switch settings per battery to give them a unique address. You also have to connect the included RJ45 battery link cables into the "Battery Link" port of each battery. Ensure your master battery dip switch 1 is on, 2,3,4 is OFF. Only the master battery CAN Bus will be enabled. You can then connect the Hubble Cloudlink into the CAN port of the master battery for communications to work.
​
​
Do I have to use the communication battery link cables if i dont want to monitor or have communications?
Short answer No. However it is recommended to still connect the battery links and set the correct addresses. This also needs to be done if you want to connect a Hubble Cloudlink.